⚠️ Safety Warning: This project features a custom power supply setup. Please proceed at your own risk. I am not responsible for any damage to your components, your board, or yourself. Work carefully, ...

Let’s say you want to blink an LED. You might grab an Arduino and run the Blink sketch, or you might lace up a few components to a 555. But you needn’t go so fancy! [The Design Graveyard] explains how ...

I'm making a glowing crystal diorama! **MATERIALS:** **Smoke machine:** - Vape - Air pump - Plastic/silicone tube - Liquid container - T/L connectors (for the tubes ...

Although [Simon Boak] had no use for an automatic paper tape punch, this was one of those intrusive project thoughts that had to be put to rest. With not a lot of DIY projects to look at, the first ...

Always make sure to configure the exact board model. If it's not the correct model it won't work ! Don't try to use unsupported boards variants, each board is specific, if it's not listed in the setup ...

Fire safety alarms are crucial in both residential and industrial environments. Early fire detection can prevent significant damage and save lives. Flame sensors offer one of the most efficient ...

Learning electronics? Then, chances are you already know what an Arduino is, or at the very least, you've heard of it. After all, it's among the most popular electronics platforms available in the ...

The following project is an update of Gary D. Patterson’s “Simplified CTC signals” in the July 1988 issue of MR. Bringing the project up to date was a large endeavour. The block control project now ...

Adafruit Metro M7 is a development board based on a 500 MHz NXP i.MX RT1011 Arm Cortex-M7 crossover MCU that follows Arduino UNO form factor and integrates the ESP32-based “AirLift” WiFi module for ...

After a time with a multimeter and scope, the othewise-undocumented Cronos board for home-build cnc machines has revealed some of its secrets. Power rails are well thought out (see below) and seem ...

CANduino v3 is the third revision of MassiveButDynamic’s CAN bus board with Arduino Nano form factor based on Microchip ATmega168PA 8-bit AVR microcontroller, Microchip MCP2515 CAN controller with an ...